Directions

The Acme Bushing database can be searched in many different ways. The first step is to select the search perimeters. (I.D. Fractional or I.D. Decimal, O.D., Length) Note: Select I.D. Decimal or I.D. Fractional as search parameters NOT both.

Example

1. Select I.D. Fractional 1/64 and O.D. 5/32 (see picture below)
2. Click Search
3. View results of Search
4. If the desired bushing is displayed click on the ANSI symbol to check stock or to place an order. If no results are returned from the query select fewer search criteria and click Search again. If the bushing desired is not in the database click on the specials button on the navigation bar on the left-hand side of screen.

IMPORTANT:
If more than 20 bushings match the search criteria then use the buttons located at the bottom of the table for searching. Only 20 results show up on each table. The number of tables returned by search is located at the bottom of each table. Example: Page 1 of 135

First Button: calls up first page of results
Second Button: calls up previous page of results
Third  Button: calls up next page of results
Fourth Button: calls up last page of results

Tips

• If no results return from query select fewer search parameters and click search again
• Select the bushing I.D. and O.D. or I.D. and Length only and Search
• Click on the specials button on the left hand side of the screen if bushing desired is not displayed